AquaMend

After proper mixing, AQUAMEND® molds like clay and may be used to patch dings, scratches, cuts, gouges, and holes in fibreglass, metal, and wooden boat decks and hulls; to repair fittings, pipes, electrical connections, leaking gaskets, water tanks, fish boxes, tubs, battery cases, sinks, spas, hot tubs, tanks, pools; to form custom gaskets, etc.

Usage instructions

Before applying, roughen and clean the area to be repaired. Then follow these easy steps:

1. Cut or twist off required amount.
2. Mix by kneading with fingers to a uniform colour. If mixing is difficult, warm AquaMend epoxy to room temperature or slightly above.
3. Apply to surface to be repaired (within two minutes of mixing). Force into any cracks or holes and strike off excess material, preferable with a tool wet with clean water.

When applying to a damp, wet or slowly leaking area, work the material forcefully into the surface and apply pressure until adhesion begins to take effect.

For Best Results: Use damp fingers for easier mixing and application. Remove excess material before hardening begins.

Curing: AquaMend epoxy has a work life of approximately 15 minutes. After 20-30 minutes, it will harden and form a tenacious bond. Final cure occurs in 60 minutes.

Examples of usage

• Repairs to damp wet areas and underwater applications
• May be applied underwater
• Rebuild holes in fibreglass, metal and wooden boat decks and hulls
• Repair leaking gaskets, water tanks, spas, hot tubs, pools, etc.
• Cures to fibreglass white colour.

Further info

Product brochure [PDF]